Distribution R. Désilets : construction formwork .

Products

Tools

« Practical and strong, all of our tools will make your job easier. »

Regardless if you want to finish or rectify a form, quickly pour concrete or finish a foundation, R.Désilets tools help you do neat work every time. Of exceptional quality, they will serve you for many years to come.

Tie Strap (Winch)

A device that attaches to the bolt of the panel, used to straighten walls and hold them firmly in place while the concrete is being poured. Simple and sturdy, this winch comes with a 30 foot strap.

Screws, Bolts, Casings

Spare parts.

Anchor Bolt

8” x 1/2” anchor bolt with bolts and washers.

Wall Straightener with Tip

This tool attaches to the bolt of the panel and allows you to slide in a 2” x 4” or 2” x 6” plank. Essential for a tight fit when two panels are installed one over the other.

Easy to use and very strong.

Holds the wall straight while the concrete is being poured.

Wall Straightener with Clamp

This easy to use 5/16” tool attaches to the bolt of the panel and allows you to slide in a vertical 2” x 4” or 2” x 6” plank at the desired height. You can then straighten the wall by tightening the screw on the plank.

Head Aligner with Clamp

Used to rectify and solidify the alignment of part of the formwork.

Head Aligner with Tip

Metal piece used to straighten and align the panel heads in order to obtain a straight concrete surface.

This tool attaches to the top of the panel on the inside and outside. You can then slide a 2” x 4” plank behind the tip on the outside of the wall and, using a hammer, tighten the plank between the tip and the panel.

Loop Wires

Strong and flexible, these are perfect for attaching steel reinforcement.

Come in practical 2 500 piece rolls.

Standard lengths available: 6” and 8”.

Automatic and Manual Wire Fastener

Tool used to twist wire.

Waterstop

Makes a watertight seal between the footing and foundation wall. 50’ or 100’ rolls (standard size).

Waterstop Welder

Tool used to weld waterstops.

Metal Chimney

Quickly fastens to the inside of the formwork for attractive and quality installation.

1/8” steel (heat resistant, recommended by authorities in the field, etc.).

Depth can be adjusted from 8” to 10”.

Compatible with all formwork systems of this type.

Very Sturdy Shovels

Shovels of different shapes and lengths for laying concrete

Aluminum Concrete Spreader

Helps evenly spread the concrete of the footings for a nice finish.

Aluminum Rake

Used to spread the cement over the desired surface.

Scraper

To better clean the panels.

Marking Powder

Fluorescent powder of excellent quality (Choice of colours and quantities, from 8 oz to 5 lbs).

Hook Belt

Securely binds the material to the truck.

Paint Diffuser

Mark the floor without having to bend down.

Bending Machine

Can bend and cut reinforcing rods up to 5/8” in diameter. Set to the desired degree.

Corner Remover

Tool that makes it much easier to remove corners and panels.

Hinged Corner Lock

For adjustment and to hold an adjustable corner at the desired angle if needed.

Horizontal H Beam Support

To place an H beam over the panels.

Shaping H

To superpose a panel over another panel.

Morin Bracket

Part to superpose a panel over another with a rod.

Stacking Plate

Firmly holds the stacked panels. The notch in the plate keeps the rod from moving, providing alignment and stability.

Line Clip

Quickly and solidly attaches a rope to the top of the panel to align the wall. Prevents you from having to nail the top of the panel, thus increasing its service life.